1. Home
  2. Ring
  3. Ring Doorbell Blinking Blue: What Each Pattern Means

Ring Doorbell Blinking Blue: What Each Pattern Means

Some links in our guides may be affiliate links; we may earn a commission at no cost to you. Disclosure.

Quick answer

A blinking blue light on a Ring doorbell is usually normal. The pattern tells you which: a blue circle filling clockwise means a battery doorbell is charging; blue moving upward means it’s joining Wi-Fi; blue spinning means someone pressed the button; a slow-flashing blue circle means a factory reset or, on some wired models, starting up.

Applies to: Ring video doorbells with a light ring, including battery and wired models. Light patterns differ between models; the model notes below come from Ring’s official light guide.

What each blue pattern means

Blue circle filling clockwise

Charging (battery models with a built-in battery). The lit part shows the level: upper-right quarter = 0–25%, right half = 25–50%, most of the circle = 50–75%, full circle flashing = fully charged. Quick Release Battery Pack models don’t show this.

Blue moving upward

Connecting to Wi-Fi during setup.

Four corner lights flashing blue

Setup finished successfully (not shown on the Video Doorbell Elite).

Blue spinning clockwise

The doorbell button was pressed.

Solid blue circle

A live call with the speaker on.

Blue circle flashing slowly

Factory reset on battery models (except Door View Cam), or starting up on the Video Doorbell Wired, Wired Doorbell 2K, Battery Doorbell Plus and Battery Doorbell 2K Plus.

Blue flashing, then white circling

Factory reset on wired doorbells and the Door View Cam.

If it keeps blinking blue while charging

  • A flashing full blue circle means charging is complete. Unplug the cable and reinstall the doorbell or battery.
  • Use the cable that came with the doorbell and a wall USB charger rather than a computer port.
  • If the level never rises, try another wall charger and cable before assuming the battery is faulty.

If it’s stuck flashing blue after a power cut

Ring’s light guide doesn’t give a fix for a doorbell stuck on blue, so work through these general checks:

  1. Give it a few minutes. A slow-flashing blue on wired models can simply be start-up.
  2. For wired models, switch the doorbell circuit off at the breaker for a minute and back on.
  3. Open the Ring app and check whether the doorbell shows as online. If not, run setup again from the app to reconnect it to Wi-Fi.
  4. If it still won’t settle, contact Ring support with your exact model and the light pattern you see.

Other colours

White patterns usually relate to setup and Wi-Fi, for example a failed setup caused by a wrong Wi-Fi password or weak signal. Red patterns usually mean low battery. Check Ring’s light-pattern guide for your exact model.

Frequently asked questions

Can I turn off the blue light on my Ring doorbell?

The light ring reports status and button presses, so it can’t be fully switched off on most models. Some light behaviour can be adjusted in the Ring app depending on the model.

Does blinking blue mean my doorbell is recording?

No. Blue patterns show charging, setup, button presses, calls, start-up and resets, not recording.

How long does a Ring doorbell take to charge?

It depends on the model and charger. The blue circle shows progress; a flashing full circle means it’s done.

Source: Ring Help: Understanding doorbell light patterns.

Last checked against official sources: October 2026. Stack Clarity is not affiliated with Ring.

SUK

Writes and checks every Stack Clarity guide against official manufacturer documentation. Spotted something out of date? Tell us.

Comments